MacDon CA20 Operators Manual - Manual (Page 93)

MAINTENANCE/SERVICE
Form 169009 91 Model Year - 2009
f. Remove nuts, screws (D), and straps (E) along
draper joint.
g. Pull draper from deck.
h. Install new draper over drive roller (F) with
chevron cleat (G) pointing to front of adapter,
and ensuring draper guides fit in drive roller
grooves (H).
i. Pull draper along bottom of adapter deck and
over draper supports (J).
j. Connect draper with straps (E), screws (D) and
nuts with screw heads facing rear of deck.
Tighten nuts so that end of screw is
approximately flush with nut.
k. Adjust draper tension. Refer to Section 8.12.1,
Draper Tension Adjustment.
G
H H
F
J
E
D
REAR OF DECK
E
D