MacDon CA20 Operators Manual - Manual (Page 20)

ADAPTER AND CASE 2300, 2500 SERIES
Form 169009 18 Model Year - 2009
5. Re-install plug on combine coupler (Q).
6. Disconnect reel fore/aft hoses (R) and (S)
(red discs) from adapter and combine
receptacles.
7. Connect hose (R) from combine to combine
coupler (T).
8. Connect hose (S) from the adapter to the
adapter coupler (U).
WARNING
To avoid bodily injury or death from
unexpected start-up or fall of raised
attachment; stop engine, remove key and
engage lift cylinder stop before proceeding
with hook-up.
j. Disengage adapter from combine with one of
the following two methods depending on
combine model.
Latch System
1. Raise feeder house fully and engage
combine lift cylinder locks.
2. Remove pin (V) and lower latch handle (W)
(one on each side of feeder house) to
disengage latch (X).
3. Raise latch handle to storage position and
secure with pin (V).
4. Proceed to step l.
Sliding Pin System
1. Raise handle (Y) on left side of feeder
house to retract pins (Z).
k. Lower feeder house until it disengages adapter
support.
l. Slowly back combine away from adapter.
U
S
V
W
X
Y
Z
Q
R
T
S
R