MacDon CA20 Operators Manual - Manual (Page 49)

D50 & D60 HEADER/ADAPTER
Form 169009 47 Model Year - 2009
l. Secure header to adapter as follows:
1. Ensure adapter arm is properly located in
header leg (J). Reinstall pin (C) in each leg
to lock header to adapter and secure with
lynch pin.
2. Return stand (A) to storage position and
secure with pin (B).
m. Lower header to ground.
n. Tilt header to almost full forward position to
increase clearance under adapter feed draper.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
o. Raise reel, shut off engine, and remove key.
Engage reel props.
p. Attach adapter deck to header cutterbar as
follows:
WARNING
Keep hands clear of the area between
guards and sickle at all times.
CAUTION
Wear heavy gloves when working around or
handling sickles.
1. If installed, remove bolts (S) at either side
of opening to allow attachment of adapter
deck.
2. Position latches (T) on transition pan (U) so
that chain (V) can be attached to the latch
hook.
3. Rotate latch (T) with a 15/16 wrench (or
equivalent) on hex (W) to raise feed deck
so that bolt (S) can be reinstalled. Repeat
for other side of feed draper.
q. Connect knife and draper drive hydraulics as
shown above using coloured plastic ties as a
guide.
(continued next page)
A
B
C
J
DRAPER DRIVE
RETURN
ELECTRICAL KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
T
W
S
U
V T