MacDon CA20 Operators Manual - Manual (Page 42)

ADAPTER AND AGCO
Form 169009 40 Model Year - 2009
5.7.2 DETACHMENT
a. Choose a level area. Position header slightly
off the ground. Stop engine and remove key
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s
Manual for instructions for use and storage
of header lift cylinder stops.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Engage the adapter float locks by lifting lever
(C) at each lock until it latches into the lock
position.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached in
either transport or field mode. If
detaching with wheel in field mode, set
wheels to storage or uppermost working
position. Otherwise header may tilt
forward so that re-attachment will be
difficult. Refer to D50 and D60 Harvest
Header / FD70 FlexDraper Operators
Manual.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or uppermost working
position. Otherwise header may tilt
forward so that re-attachment will be
difficult. Refer to D50 and D60 Harvest
Header / FD70 FlexDraper Operators
Manual.
c. If adapter is equipped with reel fore-aft/header
tilt selector, disconnect harness (D) and store
on combine.
d. Disconnect driveshaft (E) from combine and
slide driveshaft in hook (F) so that disc (G)
drops to secure driveshaft.
(continued next page)
C
UNLOCK
LOCK
G
F
E
D