MacDon CA20 Operators Manual - Manual (Page 21)

ADAPTER AND JOHN DEERE 60, 70 SERIES
Form 169009 19 Model Year - 2009
5.3 JOHN DEERE 60, 70 SERIES
Contour Master, Level Land
5.3.1 ATTACHMENT
a. Push handle (A) on combine coupler toward
feeder house to retract pins (B) at bottom
corners of feeder house.
b. Slowly drive combine up to adapter until feeder
house saddle (C) is directly under the adapter
top cross member (D).
c. Raise feeder house to lift adapter, ensuring
feeder saddle is properly engaged in adapter
frame.
d. Raise or lower header until slightly off the
ground.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
e. Pull handle (F) on adapter to release coupler
(G) from storage position. Remove coupler and
push handle back into adapter to store.
f. Pull handle (A) to horizontal position to engage
pins (B) in adapter. Check that bolts (E) on
adapter brackets are tight.
g. If pins (B) do not fully engage adapter brackets,
loosen bolts (E) and adjust bracket as required.
Re-tighten bolts.
(continued next page)
A
B
D
C
B E
B
F
G