MacDon CA20 Operators Manual - Manual (Page 57)

FD70 HEADER/ADAPTER
Form 169009 55 Model Year - 2009
k. Place blocks under center section of header to
keep it about 6 inches off the ground.
l. Adjust header angle to shallowest setting
(shortest centre link).
m. Remove lift cylinder locks and lower header to
blocks and allow the header wings to go into full
frown mode.
n. Attach adapter deck to header cutterbar as
follows:
WARNING
Keep hands clear of the area between
guards and sickle at all times.
1. If installed, remove bolts (P) at either side
of opening to allow attachment of adapter
deck.
2. Position latches (Q) on transition pan (R) so
that chain (S) can be attached to the latch
hook.
3. Rotate latch (Q) with a 15/16 wrench (or
equivalent) on hex (T) to raise feed deck so
that bolt (P) can be reinstalled. Repeat for
other side of feed draper.
o. Attach the wing float linkage to the adapter as
follows:
1. Remove pin (U) from bracket if installed.
2. Reinstall pin with springs (V) and secure
with hairpin.
p. Connect knife and draper drive hydraulics as
shown above, matching plastic cable ties.
q. If quick disconnects are installed, connect as
follows:
1. Remove covers if installed from receptacles
and hose ends.
2. Check connectors and clean if required.
3. Push hose connector onto mating
receptacle until collar on receptacle snaps
into lock position.
NOTE
Ensure hoses are clear of driveline and
adjacent structure.
(continued next page)
Q
T
DRAPER DRIVE
RETURN
ELECTRICAL
KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
P
R
S Q
U
V