MacDon CA20 Operators Manual - Manual (Page 16)

ADAPTER AND CASE 2300, 2500 SERIES
Form 169009 14 Model Year - 2009
5. Tighten jam-nuts (J) when force is correct.
6. Install pin (E) as shown to secure latch
handle in locked position.
b. Remove combine lift cylinder locks and lower
header to ground.
c. Connect combine hydraulics to adapter as
follows:
1. Disconnect reel drive hoses (K) and (L)
(white discs) from combine and adapter
receptacles.
2. Connect hose (K) from combine to adapter
coupler (M).
3. Connect hose (L) from the adapter to the
combine coupler (N).
4. Remove plug from reel lift coupler (O)
(black disc) on combine.
5. Remove red dust cap from reel lift hose (P)
on adapter and connect hose to combine
coupler (O).
6. Disconnect reel fore/aft hoses (Q) and (R)
(red discs) from combine and adapter
receptacles
(continued next page).
P
N K
L
M
L
K
R
Q
O