MacDon CA20 Operators Manual - Manual (Page 51)

FD70 HEADER/ADAPTER
Form 169009 49 Model Year - 2009
6.2 FD70 FLEXDRAPER/ADAPTER
6.2.1 DISASSEMBLY
a. Choose a level area, lower header to ground,
and raise reel fully.
b. Fully retract tilt cylinder.
c. Place spring handles (A) in the lower slot to
UNLOCK.
d. Place 6 inch (150 mm) blocks under hinge area
of cutterbar and lower header onto blocks so
that header goes into a full frown.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
e. Stop engine, remove key, and engage reel
props. Refer to D50 and D60 Harvest
Header/FD70 FlexDraper Operators Manual.
f. Remove the wing float linkage springs from the
adapter as follows:
1. Remove pin (J) from bracket so that springs
(K) drop free.
2. Reinstall pin in bracket and secure pin with
hairpin.
g. Disconnect adapter deck from cutterbar as
follows:
1. Start engine and tilt header to almost full
forward position to increase clearance
under adapter feed draper.
2. Stop engine and remove key.
WARNING
Keep hands clear of the area between
guards and sickle at all times.
CAUTION
Wear heavy gloves when working around or
handling sickles.
(continued next page)
CUTTERBAR 6 INCH BLOCKS LEVEL GROUND
REEL FROWN
UNLOCK
A
J
K