Opticon PHL 1700 - Manual (Page 2)

page
1 INTRODUCTION 3
2 INSTALLATION 4
2.1 U
NPACKING
4
2.2 D
ETAILED VIEW
5
2.2.1 Dimensions of terminal 5
2.2.2 Details of terminal 5
2.2.3 Display of terminal 6
2.2.4 Dimensions of cradle 7
2.2.5 Details of cradle 7
2.3 H
ANDLING PRECAUTIONS
8
2.4 A
SSEMBLY
9
2.4.1 Terminal 9
2.4.2 Cradle 9
2.5 I
NSTALLING
,
REPLACING AND CHARGING
BATTERIES
10
2.5.1 Required batteries 11
2.5.2 When to replace or recharge the
main battery?
11
2.5.3 When to replace the backup
battery?
11
2.5.4 How to remove the main battery? 11
2.5.5 How to install the main battery 12
2.5.6 How to recharge the rechargeable
battery pack in the cradle?
12
2.5.7 How to (re)place the backup battery
in the terminal?
13
2.6 I
NSTALLING IN A SYSTEM
13
2.6.1 Power supply for cradle 13
2.6.2 DIP switch settings on cradle 13
2.6.3 Connect cradle to computer/
modem
13
2.6.4 Connect network of cradles 13
2.6.5 Terminal on cradle 13
3 OPERATION OF THE TERMINAL 15
4 SCANNING BAR CODES 16
4.1 S
CAN
P
OSITION
16
4.2 Reading the bar codes 16
4.3 If you have problems with the
read operation
16
U
SER
’
S MANUAL
PHL 1700
LASER TERMINAL
/ IRU 1700
CRADLE
PHL-ver6-sv / printed 03 03
CONTENTS
CAUTION: This user’s manual may be revised or
withdrawn at any time without prior notice.
Copyright 2000, Opticon Sensors Europe B.V.
All rights reserved.
This manual may not, in whole or in part, be copied,
photocopied, reproduced, translated or converted to
any electronic or machine readable form without
prior written consent of Opticon Sensors Europe.
Limited warranty and disclaimers
By opening the package of this product you agree to
become bound by the liability and warranty conditions
as described below.
Under all circumstances this manual should be read
attentively, before installing and or using the product.
In no event, Opticon Sensors Europe will be liable
for any direct, indirect, consequential or incidental
damages arising out of use or inability to use both
the hardware and software, even if Opticon has been
informed about the possibility of such damages.
A serial number appears on all Opticon products.
This official registration number is strictly related to
the device purchased. Make sure that the serial
number appearing on your Opticon device has not
been removed. Servicing by our Repair Department
can only be carried out under warranty.
All Opticon products are warranted for a period of
one year after purchase, covering defects in material
and workmanship. Opticon will repair or, at its opinion,
replace products that prove to be defective in material
or workmanship under proper use during the warranty
period.
Opticon will not be liable in case modifications are
made by the customer. In such case the standard
repair charge will be applicable. The standard charge
for repair will also be applicable in case no defect is
found at all. These rules also apply for products that
are still under warranty. Therefore, you are advised
to have the product specifications always at hand.
Trademarks used are property of their respective
owners