Opticon PHL 1700 User Manual
Page 11

U
SER
’
S MANUAL
PHL 1700
LASER TERMINAL
/ IRU 1700
CRADLE
11
2.5.2 When to replace or recharge the
main battery?
There are 2 reasons for replacing (or charging)
the main battery;
as soon as possible after the battery
indicator
appears on the display.
when you are not using the terminal for an
extended period.
For instructions of (re)placing the main battery
see paragraph 2.5.4 and 2.5.5.
For instructions for charging the rechargeable
battery pack see paragraph 2.5.6.
2.5.3 When to replace the backup
battery?
When low battery mark
appears,
replace the battery without delay.
For instructions of (re)placing the backup
battery see paragraph 2.5.7.
2.5.4 How to remove the main battery?
Remove the battery
case cover. Press the
shaped part
with some force, and
pull it up.
Remove the entire
battery case cover.
To take the battery
case out, pull one side.
2.5.5 How to install the main battery
Before installing a battery case with penlite bat-
teries:
Make sure you use
the right battery size.
Place 2 batteries in
the battery holder
aligning plus (+) and
minus (-) ends as
shown on the battery
holder.
The instructions for installing the battery pack
are also applicable for the battery holder with
penlite batteries.
Remove the battery
case cover. Press the
shaped part
with some force, and
pull it up.
Remove the entire
battery case cover.
Make sure that the
direction of the
battery case is correct
and put the battery
case in.
Fit battery case cover.