Opticon PHL 1700 User Manual

Page 13

SER

’

S MANUAL

PHL 1700

LASER TERMINAL

/ IRU 1700

CRADLE

Exercise caution at all times when

working with AC-powered equipment.

Turn off your devices before

installation.

Because of the special pin-out of the

connectors, use the cables supplied
by the manufacturer.

When you need another cable for a

certain device, that is not supplied,
contact your supplier to purchase the
right cable. In case another cable is
used, take notice of the pin-out
specifications further in this manual.

2.6.1 Power supply for cradle

Make sure that you use the right

power supply.

Use for model T and SV: 9V DC adaptor
Use for model TC: 5V DC adaptor

2.6.2 Dip switch settings on cradle

Setting the DIP switches on or off will result in
enabled or disabled functions of the cradle.
(see table on next page)

Make sure power is switched off.
Open the cover of the DIP switches on the

bottom of the cradle in order to reach the
DIP switches.

2.6.3 Connect cradle to computer/modem

Connection sequence (see diagram and
dipswitch settings on next page)

Shutt off the computer.
Make sure cradle is disconnected.
Place the cradle in normal office conditions,

avoid a place under strong light (1).

Set proper baudrate on cradle (2), use

same baudrate as set on computer.

Connect the interface cable (3).
Connect the power supply (4) and power up

by power switch.

Power up the computer.

2.6.4 Connect network of cradles

(see diagram on next page)

Only 1 cradle in the network will be

connected to the PC through one RS232
cable. On this cradle the DIPswitch for
RS232 connection must be enabled.
Through this connection all cradles can
communicate to the PC.

A maximum of 16 cradles can be connected

in a network through RS485 cables. For the
cradles that are not directly connected to
the PC the DIPswitch for RS232 connection
must be set to off.

All cradles need to have the same baudrate,

for model SV to be set by dipswitch.

The first and the last cradle in the network

must have the termination resistors set by
DIPswitch.

2.6.5 Terminal on cradle

Do not place any other product than

the PHL1700 terminal in the IRU1700
cradle.

Place the terminal on the cradle as shown in
the illustration:
(Indicator on cradle: green LED)

2.6 INSTALLING IN A SYSTEM