Multiquip WRS5200 (ORIGINAL COPY) - Manual (Page 30)

page 30 — wrs5200 hydraulic roller screed • operaTion manual — rev. #0 (10/22/10)
enGine cOMpOnentS
Figure 15. Engine
The engine (Figure 15) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to the
manufacturer's engine manual for instructions and details
of operation and servicing.
The definitions below describe the basic componets of
the engine.
1.
Thermostat — Regulates the temperature of the
engine coolant.
2. oil filler cap — Remove to add engine oil.
3. starter — Starts engine when ignition key is rotated
to the "START" position.
4. oil pan — Holds a maximum of 3.5 quarts (3.3 liters)
of motor oil.
5. alternator — Provides charge for battery and voltage
for the +12 VDC electrical system.
6. injection nozzles — Injects diesel fuel into the
cylinders.
7. glow plugs — Heating element used for starting the
engine in cold weather conditions.
8. oil drain plugs — Remove to drain crankcase oil. Fill
with recommended type oil as listed in Table 5.
9. fuel filter — Prevents dirt and other debris from
entering the fuel injection system. Replace or clean
as recommended in maintenance section of this
manual.
10. oil filter — Spin-on type, filters oil contaminants.
11. oil dipstick — Remove to check amount and condition
of oil in crankcase. Refill or replace with recommended
type oil as listed in Table 5.
12. injector pump — Provides fuel under pressure to the
injector nozzles.
13. flywheel — Connect to engine coupler.
14. air filter — Prevents dirt and other debris from entering
the fuel system. Unsnap air filter cover to gain access
to filter element.