MTS SWIFT 30 Sensor - Manual (Page 94)

SWIFT 30 Sensors 94
Test Track Vehicle
Installing the Transducer
A. Push either the Angle Zero or Bridge Zero button on the front of the
TI box. Both indicators will light.
B. Rotate the tire 1 1/4 to 2 revolutions, until the Bridge Zero indicator
starts flashing. Follow the guidelines in , “Considerations for rotating a
tire,” on page 85.
C. If the Bridge Zero indicator continues to slowly flash after 2 minutes,
or if the red Fail indicator flashes, there is an error in the zero process.
Run TISTATUS to find out more information. Repeat Steps A and B. If
you continue to have an error, consult the chapter , “Troubleshooting,”
on page 127.
D. Perform , “Verifying the Quality of the Zero Procedure,” on page 95.
E. Look at your data acquisition system to verify that the SWIFT sensor is
gathering data.
S20-21
Angle Zero
Switch and Indicator
Bridge Zero
Switch and Indicator