MTS SWIFT 30 Sensor - Manual (Page 80)

SWIFT 30 Sensors 80
Test Track Vehicle
Installing the Transducer
Note To minimize negative clamping effects, you must torque the bolts in the
sequence shown.
C. Following the sequence shown in the previous figure for the transducer
being installed, torque the twenty-four M10 outer hub bolts in two
increments as shown in the previous table. See the previous note.
B OLT S IZE
T ORQUE I NCREMENT M8 M10
1st Increment 14 N•m (10 lbf• ft) 27 N•m (20 lbf• ft)
Final Torque 27 N•m (20 lbf• ft) 54 N•m (40 lbf• ft)