Lenze SCD Series - Manual (Page 91)

88
NOTE 2: Preset speeds are accepted only when DeviceNet control is set but NOT network reference.
If network reference is set, preset speed control is ignored. To simplify setup, refer to the following
parameters in the EDS file: Parameter 24 - DeviceNet Preset Command, and Parameter 38 - Keypad
Command Frequency.
NOTE 1: Refer to the following table for Frequency Source Bits representation.
BIT 2 BIT 1 BIT 0 SPEED SOURCE
0 0 0 LOCAL (keypad, analog)
0 0 1 PRESET SPEED #1
0 1 0 PRESET SPEED #2
0 1 1 PRESET SPEED #3
1 0 0 PRESET SPEED #4
1 0 1 PRESET SPEED #5
1 1 0 PRESET SPEED #6
1 1 1 PRESET SPEED #7
PRESET SPEED BITS REPRESENTATION
BYTE BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
0 NET. NET. FAULT RUN RUN
REF. CONTROL RESET REV FWD
1
2
3
21 EXTENDED SPEED CONTROL OUTPUT ASSEMBLY
SPEED REFERENCE RPM (LOW BYTE)
SPEED REFERENCE RPM (HIGH BYTE)
BYTE BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
0 NET. NET. FAULT RUN RUN
REF. CONTROL RESET REV FWD
1
2
3
100 AC TECH EXTENDED SPEED CONTROL OUTPUT ASSEMBLY
SPEED REFERENCE Hz (LOW BYTE)
SPEED REFERENCE Hz (HIGH BYTE)
BYTE BIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0
0 FAULT RUN RUN
RESET REV FWD
1 PRESET PRESET PRESET
BIT 2 BIT 1 BIT 0
103 AC TECH PRESET SPEED CONTROL OUTPUT ASSEMBLY