Lenze SCD Series - Manual (Page 33)

30
FACTORY
NO. PARAMETER NAME RANGE OF ADUSTMENT DEFAULT
(NOTE 1)
12 TB-13C FUNCTION NONE (01), 0-10 VDC (02), 4-20 mA (03), NONE (01)
SELECT PRESET SPEED #3 (04), INCREASE FREQ (05),
EXTERNAL FAULT (06), Factory Reserved (07),
DB FAULT (08), ACCEL/DECEL #2 (09)
13 TB-15 OUTPUT (SEE PARAMETER 6 - TB-14 OUTPUT) NONE (01)
14 CONTROL TERMINAL STRIP & DEVICENET (01), TERMINAL STRIP &
DEVICENET ONLY (02), DEVICENET (01)
16 UNITS EDITING TENTHS OF UNITS (01), WHOLE
WHOLE UNITS (02) UNITS (02)
17 ROTATION FORWARD ONLY (01), FORWARD
FORWARD AND REVERSE (02) ONLY (01)
19 ACCELERATION TIME 0.1 - 3600.0 SEC 20.0 SEC
20 DECELERATION TIME 0.1 - 3600.0 SEC 20.0 SEC
21 DC BRAKE TIME 0.0 - 3600.0 SEC 0.0 SEC
22 DC BRAKE VOLTAGE 0.0 - 30.0 % 0.0 %
23 MINIMUM FREQUENCY 0.0 - MAXIMUM FREQUENCY 0.0 Hz
24 MAXIMUM FREQUENCY MINIMUM FREQ - 240.0 Hz (NOTE 2) 60.0 Hz
25 CURRENT LIMIT 30 - 180 % (NOTE 3) 180%
26 MOTOR OVERLOAD 30 - 100 % 100%
27 BASE FREQUENCY 25.0 - 500.0 Hz (NOTE 4) 60.0 Hz
28 FIXED BOOST 0.0 - 30.0 % 1.00%
29 ACCEL BOOST 0.0 - 20.0 % 0.00%
30 SLIP COMPENSATION 0.0 - 5.0 % 0.00%
31-37 PRESET SPEEDS 0.0 - MAXIMUM FREQUENCY 0.0 Hz
38 SKIP BANDWIDTH 0.0 - 10.0 Hz 0.0 Hz
39 SPEED SCALING 0.0 - 6500.0 0
PARAMETER MENU (CONT’D)
NOTE 1: Factory defaults are shown for a 60 Hz base frequency. See Parameter 48 for 50 Hz base frequency.
NOTE 2: Maximum setting is 999.9 Hz on drives with High Output Frequency option. Consult the factory.
NOTE 3: If LINE VOLTAGE is set to LOW, maximum setting is 150%.
NOTE 4: Maximum setting is 1300.0 Hz (factory default is 999.9) on drives with High Output Frequency option.
Consult the factory.