Lenze SCD Series - Manual (Page 21)

18
NOTE: The function of terminals TB-13A, TB-13B, TB-13C, TB-14, TB-15, TB-30, and TB-31 are
dependent on the programming of certain parameters. Refer to Sections 14.0 - PARAMETER MENU
and 15.0 - DESCRIPTION OF PARAMETERS.
Additional information on operating the drive from the terminal strip can be found in Section 10.0 -
CONTROL WIRING. The following diagrams provide a quick reference to wire the drive for the
most common configurations.
11.0 SCD CONTROL WIRING DIAGRAMS
11.1 SCD TERMINAL STRIP
Shown below is the terminal strip on the main control board, along with a brief description of the
function of each terminal.
1 4 5/25 11 2 CAN+ V+ 14 13B 13C 15 13A 30 V-
STOP
DIGITAL INPUT REFERENCE
0-10 VDC or 4-20 mA SPEED REFERENCE INPUT
0-10 OR 2-10 VDC OUTPUT: FREQ. OR LOAD
0-10 OR 2-10 VDC OUTPUT: LOAD
ANALOG COMMON
START
TB-13A FUNCTION SELECT TB-13B FUNCTION SELECT TB-13C FUNCTION SELECT
OPEN-COLLECTOR OUTPUT OPEN-COLLECTOR OUTPUT
DEVICENET TM INTERFACE
Removable Connector
(Refer to Appendix B)
12 31 SHLD
12 VDC SUPPLY (50 mA MAX)
CAN-