Lenze SCD Series - Manual (Page 81)

78
If Attribute #5 NET CONTROL is set to 1, the RUN and STOP events are triggered according to the
following event table:
NOTE: If ACT PARAMETER #17 DIRECTION is set to FORWARD ONLY, the drive will not be
able to run in the reverse direction.
ATTRIBUTE ID ACCESS RULE NAME DATA TYPE VALUE
1 GET NO. OF SUPPORTED USINT 16
ATTRIBUTES
2 GET ATTRIBUTE LIST ARRAY
3 GET / SET RUNFWD BOOL 0 to 1
4 GET / SET RUNREV BOOL 0 to 1
5 GET / SET NETCTRL BOOL 0 to 1
6 GET STATE UINT 3 = Ready
4 = Enabled
7 = Faulted
7 GET RUNNINGFWD BOOL 0 to 1
8 GET RUNNINGREV BOOL 0 to 1
9 GET READY BOOL 0 to 1
10 GET FAULTED BOOL 0 to 1
11 GET WARNING UINT 0 (Not Supported)
12 GET / SET FAULTRST BOOL 0 to 1
13 GET FAULT CODE UINT 0 to 65535
15 GET CTRLFROMNET USINT 0 to 1
16 GET / SET ACTION ON LOSS USINT 0 = Fault
OF DEVICENET 1 = Ignore Comm. Fault
2 = AC Tech Specific
17 GET / SET FORCE TRIP BOOL 0 to 1
INSTANCE 1
CONTROL SUPERVISOR CLASS ATTRIBUTES
The drive shows the "nF" fault on the LED display
ATTRIBUTE RUN FWD ATTRIBUTE RUN REV TRIGGER EVENT RUN TYPE
0 0 STOP N/A
0 --> 1 0 RUN RUN FORWARD
0 0 --> 1 RUN RUN REVERSE
0 --> 1 0 --> 1 NO ACTION N/A
1 1 NO ACTION N/A
1 --> 0 1 RUN RUN REVERSE
1 1 --> 0 RUN RUN FORWARD