Lenze EMZ9371BC - Manual (Page 110)

8 Parameterisation 9300 series
Transmit parameter sets
EDK9371BC DE/EN/FR 3.1 110
l
Parametrierung 9300−9371BCme93
Transmit parameter sets
Parameter settings can be easily copied from one standard device to another by using the
keypad.
For this purpose use the "Load/Store" menu
}
Danger!
During the parameter transfer from the keypad to the standard device the
control terminals can adopt undefined states!
Therefore the plugs X5 and X6 must be disconnected from the standard device
before the transfer takes place. This ensures that the controller is inhibited and
all control terminals have the defined state "LOW".
Copying parameter sets from the standard device into the keypad
)
Note!
After copying the parameter sets into the XT keypad (C0003 = 11), always the
parameter set that was loaded last via C0002 is activated.
Like this the current parameters also remain active after copying:
ƒ Save the current parameters in the parameter set before copying and load
this parameter set in the controller via C0002.