Boss Audio Systems BR-900CD - Manual (Page 28)

28
Turning On / Off the BR-900CD
Turning On the Power
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Before you turn the power on, make sure of the
following points.
❒ Are all external devices connected properly?
❒ Is the volume on the BR-900CD and all other devices
completely lowered?
❒ Is the memory card inserted?
* The BR-900CD is shipped with a memory card already
inserted in the slot.
2. Lower the MASTER fader on the BR-900CD.
fig.00-306
3. Turn on the devices connected to the input jacks (i.e.,
GUITAR/BASS, MIC 1, MIC 2, or LINE IN).
4. Turn on the POWER switch located on the rear panel.
fig.00-307
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
5. Turn on the device connected to the output jack (i.e.,
LINE OUT or DIGITAL OUT).
If you are using the AC adaptor, make sure that the AC
adaptor does not become unplugged during operation. If the
AC adaptor becomes unplugged accidentally, the recorded
data may become damaged.
Turning Off the Power
1. Make sure that playback of the song is stopped.
Always make sure that the recorder is stopped before
turning off the power to the BR-900CD. Turning off the
power while recording or playback is in progress may result
in the deletion of (song) data, mixer settings, and/or effect
patch data.
2. Turn off the power to each device in the reverse order
used for powering up.
3. Turn the BR-900CD’s POWER switch off.
Play Screen
The Play screen is the most fundamental screen of the
BR-900CD, and is the first screen that appears when the
BR-900CD is turned on (see below).
fig.00-308d