beautypg.com

Memory cards supported by your br-900cd, How to remove the card protector – Boss Audio Systems BR-900CD User Manual

Page 16

background image

16

Introduction to the BR-900CD

Memory Cards Supported by
Your BR-900CD

The BR-900CD uses CompactFlash cards as the storage
media for recording and playback.

The BR-900CD uses 32 MB to 1 GB CompactFlash cards with
a 3.3 V power supply.

For more on supported memory cards (CompactFlash) for
the BR-900CD, refer to “About Memory Cards” (separate
sheet).

CompactFlash Type II cards are not compatible.

CompactFlash cards are available at your nearest computer
or digital camera shop.

Formatting the memory card
(CompactFlash)

CompactFlash cards bought at a computer shop, or ones
previously used with a digital camera cannot be used as is
with the BR-900CD.

These CompactFlash cards must first be initialized for use
with the BR-900CD.

For more details regarding initializing, see p. 31, p. 196.

234

* CompactFlash and

are trademarks of SanDisk Corpo-

ration and licensed by CompactFlash association.

235

* BOSS Corporation is an authorized licensee of the

CompactFlash™ and CF logo (

) trademarks.

How to remove the card
protector

To prevent theft of the memory card (CompactFlash), the BR-
900CD is shipped from the factory with a card protector.

fig.00-103

To remove the card protector, use the following procedure.

1. Make sure the card cover is closed, then the BR-900CD

over.

* When turning the unit upside-down, get a bunch of

newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.

* When turning the unit upside-down, handle with care to avoid

dropping it, or allowing it to fall or tip over.

2. Using a coin or

flathead screwdriver,
unscrew and remove
the coin screw from
the bottom panel.

3. Pull out the card

cover in the direction
indicated by the
arrow.

4. To prevent loss of the

card protector after it
is removed, place it as
shown in the figure.
Insert the card
protector in the slot as
indicated by the
arrow.

5. Turn the BR-900CD

back over to its
original position.

Should you remove the screws, make sure to put them in a
safe place out of children’s reach, so there is no chance of
them being swallowed accidentally.

Card Cover

Card Protector