INFICON Sensistor ILS500 Leak Detection System - Manual (Page 89)

Technical Data 89
ninb63e1-f (1410)
Printing of results
The printer port prints the result of every test. In hand probe mode the result printed is
“ACCEPT” or “REJECT” followed by date & time and recipe name (if used) and end
Char New Line (0A, LF).<09> (Char Tab, 09) is used as a separator.
For Example: "TEST_ACCE<09>2013-09-04 13:23:03<09>Factory Default<0A>"
After an active probe test cycle the gas analysis value from the ISH2000 is printed. The
printout can be “2.4E+00A<09>2013-09-04 13:23:03<09>Factory Default<0A>”.
See the ISH2000 manual. If the test cycle is rejected by any other test this will be
printed. Followed with date, time and recipe name. Hardware error prints “ERROR”.
For example: “ERROR<09>2013-09-04<09>Factory Default<0A>”.
On the ILS500 (Service/RS232), you can choose if you want to include time and date in
every result from the ILS500 or not. If it’s on the result will be:
"TEST_ACCE<09>2013-09-04 13:23:03<09>Factory Default<0A>"And if it’s
off:“TEST_ACCE<0A>"
Results from ILS500
Results Explanation
TEST_ACCE Test accepted
TEST_REJE Test rejected
USER_FAIL User has pressed stop
EVAC_FAIL Evacuation failed
VDEC_FAIL Vacuum decay test failed
FILL_FAIL Tracer gas filling failed
PDEC_FAIL Pressure decay test failed
BLOC_FAIL Blockage test failed
REFI_FAIL Tracer gas refill failed
COMM_FAIL Communication with ISH2000 failed
TEST_STRT Test cycle started
TEST_DONE Test cycle finished
FILL_DONE Filling completed
CALI_STRT Calibration started
CALI_FAIL Calibration failed
CALI_DONE Calibration successful
RECH_DONE Recipe change done
RECH_FAIL Recipe change failed
ERROR Hardware error on ILS500