ETC Unison Echo Preset Station - Manual (Page 6)

E T C I n s t a l l a t i o n G u i d e
Echo Preset Station Installation
Echo Preset Station Page 6 of 6 ETC, Inc.
Power must be connected to the station to assign the presets. To set the
consecutively numbered presets for any station:
Step 1:
Press and hold the “MODE”
button for three seconds.
“MODE” is found on the front of
the station electronics near the
middle preset button.The LED
beneath the MODE button will
illuminate.
Step 2: Press the first preset button on
the station a number of times
equal to the first preset you want
the station to control. For
example: press it 6 times to
associate the station with
presets 6-10 on a 5-button
station (6-15 on a 10-button
station). The first preset button
will flash to indicate the first preset number. The number of flashes
equals the station’s starting preset number.
a: After 90 seconds of inactivity, the “MODE” status will time out and
any changes will be aborted.
b: Button presses are cumulative. If you need to increase the
desired number, press the first preset button additional times.
c: If you have added too many, wait for the 90 second time-out to
abort the changes and then repeat this procedure.
Step 3: Once you have added the desired number of presses, press and
release the “MODE” button. The first preset button will now match
the number of presses, with subsequent presets increasing by one.
Changing LED color
Stations default to illuminating preset buttons in green. To change the color of
the LEDs for any station:
Step 1:
Press and hold the “MODE” button for five seconds. “MODE” is
found on the front of the station electronics near the middle preset
button.The LED beneath the MODE button will illuminate and all of
the preset buttons will display in their current color.
Step 2: Press the first preset button to cycle through the available colors
until you find the desired one. After 90 seconds of inactivity, the
“MODE” status will time out and any changes will be aborted.
Step 3: Press and release the “Mode” button. The selected color of the
preset buttons for that station will display.
Service
If you have any difficulties installing your system or with system startup please
contact ETC Technical Services at the office nearest you. ETC contact
information is located at the bottom of page 1.
MODE Button on
5-button station
MODE Button on
10-button station