ETC Unison Echo Preset Station - Manual

E T C I n s t a l l a t i o n G u i d e
Echo Preset Station Installation
Echo Preset Station Page 1 of 6 ETC, Inc.
Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736
London, UK  Unit 26-28, Victoria Industrial Estate, Victoria Road, London W3 6UU, UK  Tel +44 (0)20 8896 1000  Fax +44 (0)20 8896 2000
Rome, IT  Via Pieve Torina, 48, 00156 Rome, Italy  Tel +39 (06) 32 111 683  Fax +44 (0)20 8752 8486
Holzkirchen, DE  Ohmstrasse 3, 83607 Holzkirchen, Germany  Tel +49 (80 24) 47 00-0  Fax +49 (80 24) 47 00-3 00
Hong Kong

Rm 1801, 18/F, Tower 1 Phase 1, Enterprise Square, 9 Sheung Yuet Road, Kowloon Bay, Kowloon, Hong Kong

Tel +852 2799 1220
Service: (Americas) [email protected]

(UK) [email protected]

(DE) [email protected]

(Asia) [email protected]
Web: www.etcconnect.com

Copyright © 2013 ETC. All Rights Reserved.  Product information and specifications subject to change.
7140M2110  Rev A  Released 2013-03  ETC intends this document to be provided in its entirety.
Overview
Echo preset stations are used to activate built-in presets in compatible power
control products.
Stations mount using a standard single-
gang back box (RACO 690 or equivalent),
or an optional surface mount backbox
(ETC part number 7081A2004-1). Station
faceplates and buttons are available in
cream, ivory, grey, black and signal white.
Preset stations are provided with station
electronics, buttons, faceplate, a
termination kit, and installation hardware.
Installation Requirements
Preset station wiring uses (1) Belden 8471 and (1) 2.5mm
2
(14 AWG) ESD ground
wire. Wiring is topology-free and may be bus, star, loop, home run or any
combination of these. Data wiring is limited to a total of 1640 feet (500 meters)
.
NEC Class 2 product to be wired in accordance to NEC Article 725 and local
jurisdiction requirements.
Setting Station Functionality
Before installing, you must first assign an
address to the station and, if desired, adjust the
station’s functionality. Address is set using the
two numbered wheels on the rear of the station.
Functionality is set using the DIP switches found
just below the numbered wheels. The label on the
rear of the station identifies these components
and functions.
Setting the Address and Space
Station address is defined by the two numbered
wheels found on the back of the station. The top
address wheel defines the station address (1-16).
N o t e : ETC requires that all stations be grounded by using grounded metal
conduit or a 14 AWG ESD drain wire. All control wiring should be
installed and terminated by a qualified installer and should follow
standard wiring installation practices.
Address wheel
Space wheel
DIP switches