ETC Unison Echo Preset Station - Manual (Page 4)

E T C I n s t a l l a t i o n G u i d e
Echo Preset Station Installation
Echo Preset Station Page 4 of 6 ETC, Inc.
e: Attach the ground spade onto the preset station ground spade
(indicated above).
Installing the Station in the Backbox
Spacers are provided to help position the station and cover flush with the wall in
flush mount applications. The spacers are not used with surface mount
backboxes.
Step 1:
Insert the station electronics and wiring into the backbox. The
arrow on the mounting plate must point up.
Step 2: If needed, fold sections of the spacer over each other and press
them together to achieve the required thickness to fill the gap
between the station and backbox. Cut off any excess spacers and
place the spacer between the station and backbox.
Step 3: Secure the station with two screws. If using spacers, make sure the
screws pass through them.
Step 4: Install the button caps (included with the faceplate kit) so that the
clear light tunnels protrude through the caps.
N o t e : A ground connection (14 AWG) is required for any station not
installed with grounded metal conduit.
N o t e : For some flush mount applications with certain trim rings it may be
necessary to remove the station’s back cover for insertion into the
backbox.
C A U T I O N : Overtightening of the mounting screws may result in poor button
activation.
1
3
2
4