ETC SineWave Power Module (DMX) User Manual
Page 19
IES PowerModule Operators’ Manual v1.3
19
DMX control ........................................................8
Navigation through the menus.................................6
no control
error message.............................................13, 15
no load
error message.............................................13, 15
Non-dim operation .............................................1, 10
defined ............................................................1, 4
non-dim switch
setup .................................................................10
ON LED ...................................................................3
output
fault finding .......................................................15
Over temperature
error message...................................................15
overload.................................................................13
error message...................................................15
Passwords .....................................................1, 6, 13
setup .................................................................13
Phase-On and Phase-Off ..................................1, 12
Pin connections .......................................................3
Positioning ...........................................................1, 2
Power connections ..............................................2, 3
power supply
checking..............................................................5
priority channels
setup .................................................................11
Product range ......................................................1, 2
Programming .......................................................1, 6
Programming Advice ...........................................1, 6
PROPortional
mode defined ....................................................12
RCBO
fault finding .......................................................15
RCD
fault finding ....................................................... 15
Reset
factory defaults ................................................. 14
Response speed
defined............................................................ 1, 4
Response time .................................................... 1, 9
response times
setup................................................................... 9
reverse phase operation...................................... 1, 4
Safety.................................................................. 1, 3
Serial address ..................................................... 1, 8
setup................................................................... 8
short circuit
error message ............................................ 13, 15
Sleep mode ....................................................... 1, 13
setup................................................................. 13
SOFT START
mode defined.................................................... 12
software
checking installed versions................................. 5
Specifications .................................................... 1, 17
standards .............................................................. 18
Start Mode......................................................... 1, 12
setup................................................................. 12
Status reporting
defined............................................................ 1, 5
temperature
error message ............................................ 13, 15
Unpacking ........................................................... 1, 2
voltage
error message ............................................ 13, 15
Voltage regulation ............................................. 1, 11
setup................................................................. 11
XLR
pin connections .................................................. 3