ETC Unison Paradigm Virtual Touchscreen - Manual (Page 7)

E T C S e t u p G u i d e
Paradigm Virtual Touchscreen
Paradigm Virtual Touchscreen Setup Guide Page 7 of 8 Electronic Theatre Controls, Inc.
Add New Event
Step 1: Click the [Add] button, the “Timed Events” wizard displays.
Step 2: Specify a name for the new event.
Step 3: Specify the “Start” time.
• If Time is selected, additional selection for to specify the time is required.
• If Sunrise or Sunset are selected, additional selection for an “Offset” is required. An
offset is specified as an additive or a negative day, hour and/or minutes setting from
the astronomical time.
• If Event Offset is selected, additional selection of an event and the offset time is
required.An offset is specified as an additive or a negative hours and/or minutes
setting from the event time.
Step 4: Specify the “End” time. The options for the “End” time are similar to the “Start” time, except
Duration is now an option. When Duration is the selected “End” time, you will also be
required to specify the hours and minutes the new event should run from its “Start” time.
Step 5: If an override was previously created in LightDesigner for application to the new event,
select the override from the “Override” drop down. For more information on overrides,
reference the Paradigm LightDesigner online help system.
Step 6: If the new event should be allowed to play, even on protected days, click the “Allow on
Protected Days” checkbox.
Step 7: Click “Sync at boot” to ensure the Timed Event information is synchronized with the
Paradigm server.