Backup memories, Preparation, Record a backup memory – ETC SmartFade v3.0.1 User Manual
Page 77: Clear levels, Preparation record a backup memory clear levels
7
DMX Backup
71
Backup memories
The backup memories are recorded by connecting the DMX output of an external console
to the DMX in port of your SmartFade console when it is started in Backup Mode.
Preparation
Step 1:
Set DMX In:To Memory.
Step 2:
Connect the DMX out of the external console to DMX in of your SmartFade
console.
Step 3:
Bring up Fader 1 (or Last) to allow DMX In.
Step 4:
Make sure the Grand Master is at full, and that BLACKOUT is off.
Record a Backup Memory
Set up a look you want to record in the console connected to DMX In.
Test memory
Bring down the fader controlling DMX In. Move the fader of this memory up. The same look
you recorded should appear on stage. The light in the bump button of the fader will be
dimmed to show that it has content.
Clear Levels
Clear may be used to clear output levels.
Action
Console
Feedback
1. Activate recording
Buttons that can record in this mode will blink
at full. If there is a memory stored already,
this button is dimmed (press CLEAR to exit).
2. Select fader
...
or
...
The moment the bump button is pressed, the
memory is stored. Press UNDO to undo this
recording.
Action
Console
Feedback
Clear levels from one
memory
and
...
or
and
...
The selected fader is set to zero. Bring the
fader down and back up to restore.
Clear all levels
and
All faders and the Stack is set to zero. Bring
the faders down and back up to restore.
Clear all levels
All faders and the Stack is set to zero. Bring
the faders down and back up to restore.
REC
MEM
1
24
1
48
CLEAR
1
24
CLEAR
1
48
CLEAR
MEMS
CLEAR
CLEAR
CLEAR