ETC SmartFade v3.0.1 - Manual (Page 31)

2
Setup 25
Buttons
You can set the overall intensity for the LED buttons. This is done from the Buttons menu.
Menu>Settings>[Buttons]
Disable Recording
Select OFF to allow recording and ON to disable recording.
Menu>Settings>[Recording]
Crossfade faders
The direction in which the Crossfade faders advance to the next step in STACK mode is set
in the Settings menu.
Menu>Settings>[Crossfade faders]
There are two choices of behavior
• Upwards only, meaning that you will need to pull the faders back to the bottom before
fading "up" into the next cue.
• Both ways, meaning that each time you move the faders from bottom-to-top or top-to-
bottom you will fade into the next cue in the stack.
Software Version
You can verify what software version your console is running in the Diagnostics menu.
Menu>Diagnostics>[Software version]