Tap mode for the stack, N o t e – ETC SmartFade v3.0.1 User Manual

Page 68

SmartFade v3.0.1 User Manual

Tap Mode for the Stack

Tap Mode allows the recording of actual elapsed time for each step of the Stack by means of

the GO button. It should set to OFF at all times unless a timed recording is being made.

Step 1:

First record a Stack in the normal way

Step 2:

Open the Sequences menu:

Menu>[Sequences]

Step 3:

Use the wheel to select the Stack (XF).

Press (MENU) to confirm.

Step 4:

Select Tap mode

Menu>Sequences>Playback>Step Timing>[Tap mode]

Step 5:

Use the wheel to set On.

When TAP mode is on an asterisk is displayed in the bottom right position of the

LCD.

Step 6:

Press GO for each stack step at the appropriate time and the wait time is stored

for subsequent playback, independently for each of the steps. Only wait times

are affected by Tap mode.

Step 7:

Once a recording has been timed in this way Tap mode should be turned off to

play back with the recorded times.

Step 8:

Press EXIT to confirm and exit.

N o t e :

You can reset all wait times set with Tap to zero.