ElmoMC SimplIQ Digital Servo Drives-Whistle Installation Guide - Manual (Page 21)

Whistle and Tweeter Installation Guide Installation
MAN-WHTWIG (Ver. 1.604)
www.elmomc.com
21
3.4.2. Tweeter
The Tweeter was designed for mounting on a printed circuit board (PCB) via 2 mm pitch 0.51
mm square pins. When integrating the Tweeter into a device, be sure to leave about 1 cm
(0.4") outward from the lower board to enable free air convection around the Tweeter. We
recommend that the Tweeter be soldered directly to the board. Alternatively, the Tweeter can
be attached to socket connectors mounted on the PCB.
Note: Elmo recommends you leave approximately 1 cm (0.4 in) of space on the side opposite
the terminals to allow for free air convection.