Det-Tronics Mac - w/Supercard - Manual (Page 46)

Zone Configuration
Zones are provided primarily to simplify the programming of custom
graphics. They are operator configured logical groupings of up to 64
nodes, in any order, and from any attached LON. EagleVision supports
up to 256 zones. Zones are configured in the following manner:
1. Select Zone Configuration from the Configure menu:
2. The Zone Configuration screen is displayed:
This screen displays the zone number and its name. The zone number
is referenced by the zone status display and by XCMD’s in graphic
programming, the name can be any alphanumeric combination up
to 45 characters in length. The name is used only on this screen.
For maximum performance, do not leave any blanks in the zone assign-
ments. If additional zones will be added later, add them to the end. Blank
spots are inefficient and degrade performance!
Zone Configuration ( Á6)
2.33
95-8434
A1808
A1809