Det-Tronics Mac - w/Supercard - Manual (Page 30)

A variety of onscreen pushbuttons and switches control the configuration.
These controls are described below.
Hiway Polling
Switch this off to stop requesting data from the gateway.
In the multi-port version there is one switch per port. When hiway polling
is switched off for a port, you can not access the point displays for that
gateway.
Last MOD Error
Displays the decimal value of the last Modbus error code. Refer to the
Modbus protocol for a listing of Modbus error codes. The clear button
will reset the error.
Status Counters
Allows you to monitor communications between the OIS and the gate-
way. The clear button can be used at any time to reset the counters of a
given port to zero.
In the four port version, holding down the option key while selecting any
“clear” button will reset all four sets of counters to zero.
Serial Port Settings
This dialog box allows you to adjust the communication parameters
between the OIS and the gateway(s). These settings must match the gate-
way settings. Depending on the OIS hardware configuration, either the
single port or four port version for serial settings dialog box will appear.
Driver Settings ( Á3)
S
INGLE
P
ORT
V
ERSION
2.17
95-8434
!
A1788