Det-Tronics Mac - w/Supercard - Manual (Page 59)

Inhibit Active This indicator will turn red when the point has
been “inhibited” by using the point display’s
inhibit button. When “inhibited” any gateway
relays programmed to monitor the status of
the point will ignore its data. In addition, the
gateway faceplate will not respond to status
changes in the inhibited point.
Sensor Fault A sensor related fault has been detected. The
fault could be caused by a sensor wiring
problem, a sensor input that is below the
threshold for normal operation, or by an
invalid configuration where one or more set-
points is inconsistent with the type of device
specified.
This status bit has two different meanings. “Sensor fault” or “digital input
1.” Refer to the “System Configuration Matrix” (95-8453) for details.
Invalid Config. Invalid configuration data has been received.
This could include type code, configuration
word, calibration gas level or alarm setpoint
level.
It is not possible for a device to receive invalid configuration data from
EagleVision, however it is possible for a third party Modbus RTU master
to write invalid data to a module through the gateway.
Goto Point This button calls up a keypad allowing the
operator to go directly to any point on any of
the attached LON’s.
Next/Previous Point These buttons allow the operator to view the
point displays for the next higher or lower
configured device connected to this gate-
way’s LON.
Inhibit Select the Inhibit button to inhibit the current
point. When a point is inhibited, the gateway
relays will not respond to any events or
alarms generated by this module. Information
from this module will be displayed on the
screen and events configured in EagleVision
will respond.
Reset Relay Click on the Reset Relay button to reset the
communication module’s relay.
Acknowledge Select Acknowledge to acknowledge all
events, zone events and silence any audible
alarm.
Communication Module Point Display
P
USHBUTTON
F
UNCTIONS
3.5
95-8434