Dascom T2150 User Guide - Manual (Page 24)

The control panel User guide
14
Messages in the LC
display
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Initializing). Below you
will find a list of messages with brief descriptions of each message.
The messages are described in greater detail in the chapter
(see Er-
ror messages via the display, page 100) .
Message Meaning
Eject error The printer cannot eject the paper/
advance it to park position.
Hardware Alarm Internal hardware error, contact your dea-
ler or service technician.
Initializing This message appears during the prin-
ter’s initializing phase after switching on
the printer.
Load error The printer cannot draw in the loaded
paper.
Load paper from The printer has detected paper end
during operation/printer was switched on
with no paper loaded.
Loading default Factory defined parameters will be
reloaded in all available menues after
switching on the printer.
Out of paper The printer has detected paper end
during operation / printer was switched on
with no paper loaded.
Parity error A parity error during data transmission is
indicated.
Park position Printer was switched on with no paper
loaded.
Press any key The user is requested to press any key.
Selftest After power-on, the printer executes a
short hardware self-test.
Tear Paper off The user is requested to tear off paper
which has been advanced to the tear
edge.