Selecting character density and font – Dascom T2150 User Guide User Manual

Page 39

User guide

Paper handling

Selecting character
density and font

You can use the CPI (Character Per Inch) key in setup mode to sel-
ect the number of characters per inch to be printed. You can use the
Font key to select resident fonts.

Press the Setup key, then the Char (4) key.

Press the CPI (4) or Font (1) key (in our example, press CPI).

Use the

(2) or

(3) key to set the desired character density. Con-

firm the selection by pressing the Set (1) key.

You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.

If you pressed the Font (1) key, use the

(2) or

(3) key to select

the desired font. Confirm the selection by pressing the Set (1) key.

You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.

Press the Setup key. The printer returns to the initial status.

It is also possible to press the Online key. The printer then changes
directly to online mode.

The selection made will not be retained after switching off the
printer. For more details on how to set the character density
and fonts permanently, please refer to the chapter

Setting cha-

racter density (CPI) (page 50)

and

Selecting font (Font) (page 49)

Adjust

Paperway

Char

Online

Setup

Adjust Paperway
Menu Char

Online

Setup