Dascom T2150 User Guide - Manual (Page 110)

Troubleshooting User guide
100
Error messages via the display
Message Possible cause Corrective action
The printer cannot eject the paper
or cannot place the paper in the
park position. Check the following:
`
Whether the paper path is blok-
ked by a foreign object.
`
Whether the paper is damaged.
`
Whether the upper friction is
down and clicked into place.
`
Whether the printhead gap is
too small; see section
Setting
the print head gap , (page 38).
The printer cannot feed in the
loaded paper. Check the following:
`
Whether the paper path is blok-
ked by a foreign object.
` Whether the paper is damaged.
`
Whether the tractors are closed
and locked.
`
Whether the paper is too tight or
loose.
` Whether the paper is within the
specified range.
Details see section Loading paper ,
(page 30)
alternating with
The paper has run out during ope-
ration.
1 Printer is switched on but no pa-
per is loaded in the displayed
(active) paper compartment.
2 The paper is not fed past the li-
ght barrier.
`
Insert paper in the active sheet
feeder.
`
Place the paper more to the left.
If the display shows Online or Off-
line instead of Print, the printer
has loaded no paper and there is
no print job. It is no error message
in this case, actions are not requi-
red.
Eject Error
Load Error
Load paper from
...
Printing