Lc printing – Dascom T2150 User Guide User Manual
Page 152
Emulations
User guide
142
LC printing
Certain professional applications may require unusually large char-
acter sizes. Therefore your printer has the possibility of scaling stan-
dard size characters up to factor 99 by means of control sequences
(LCP*).
The Header sequence defines the parameters (e.g. height) once.
This definition remains until the printer is switched off.
The printable LCP* information is transmitted in an LCP “bracket”
(SI).
The following character sets (with national characters) are available:
The character sets are selected via the following LCP sequence
ESC ”P“ ”L“ ”S“ n ESC ”\“. The value of n may range between 01 and
02 (as ASCII characters) – see ID column in the above table.
To select e.g. the german character set, you must use the following
data set:
The printout of LCP characters can be selected in all of the
emulations. Prerequisite: Printer must be in Barcode mode.
Note that this printer supports some scalable fonts in the
LQ-2170 emulation if a compatible driver is used.
* Large Character Printing
ID
23
24
40
5B
5C
5D
5E
60
7B
7C
7D
7E
US ASCII
01
#
$
@
[
\
]
?
`
{
|
}
¯
GERMAN
02
#
$
§
Д
Ц
Ь
?
`
д
ц
ь
Я
ASCII
ESC
P
L
S
0
1
ESC
\
hex.
1B
50
4C
53
30
31
1B
5C
dec.
27
80
76
83
48
49
27
92