Dascom T2150 User Guide - Manual (Page 95)

User guide Advanced menu
85
Automatic gap adjustment
(AGA) This function allows you to switch the Automatic Gap Adjustment
(AGA) off or on.
Select the AGA menu (3).
Setting options: Off/once/always
Default setting:
always
AGA=always: The printer checks the paper thickness:
– after power-on
– in single-sheet mode: every sheet
– in fanfold paper mode: each time the paper path is changed and
atpaper end.
AGA=once: The printer checks the paper thickness only once after-
power-on for each selected paper path and after paper end.
AGA=Off: selects manual gap adjustment; the value can be set for
eachpaper source and each of the 3 menus available.
Confirm the setting by pressing the Set (1) key. The printer automat-
ically leaves test mode and assumes online mode.
Paper handling (Paphand) The Paphand group of menus improves the possibilities for the trou-
blefree printing of paper with properties likely to cOffe problems
(perforations etc.) or paper of poor finish.
Put the printer into Test mode by pressing the key Online while
switching on the printer. The display shows ASCII80 ASCII136.
Change to the parameter group Formlen AGA by pressing the key
Next three times.
Select the Paphand menu (2).
Select the Head up menu (2).
Formlen AGA
Online
Setup
Back Next
2 1 3 4
AGA=always *
Online
Setup
Set < > Exit
2 1 3 4
Paphand CX-bid
Online
Setup
Back Next
2 1 3 4
Head up Pagewid
Online
Setup
Back Next
2 1 3 4