Dascom T2150 User Guide - Manual (Page 96)

Advanced menu User guide
86
Increasing the printhead gap
(Head up)
With this function you can increase the printhead gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting: Off
If the parameter is set to On, the printhead gap increases during
form feed and line feed four lines before and after the perforation on
the form (= protected zone). The printhead gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
Printing is possible in the protected area.
Confirm the setting by pressing the Set (1) key.
Paper width (Pagewid) This parameter determines the actual paper width.
Select the Pagewid menu (3)
Setting options: From 20 to 80 in 1/10 inch steps (narrow printer)
From 20 to 136 in 1/10 inch steps (wide printer)
Default setting: 80 or 136/10 inch
(80/136 characters at 10 characters/inch)
If Head up = On, the printhead moves to the calculated centre of the
paper during the time the paper is moving in the protected zone. If
Rightzo = On (see below), the printhead moves out of the perfora-
tion zone on the right as long as the paper is bOng transported.
Set the printing width rather than the actual paper width.
Confirm your settings with the Set key (1) and press the Next key (4)
to access the next group of parameters.
Head up=Off *
Online
Setup
Set < > Exit
2 1 3 4
1
2
2
3
4
5
6
1 Top edge of form 4 Form separation perforation
2 Paper transport strip 5 Protected zone
3 Bottom edge of form 6 Transport holes
Head up Pagewid
Online
Setup
Back Next
2 1 3 4
Pagewid=136/10"*
Online
Setup
Set < > Exit
2 1 3 4