Further settings (special), Error handling (errmode), Block end character (blockend) – Dascom T2150 User Guide User Manual
Page 65
User guide
The Menu
55
Further Settings (Special)
This parameter subgroup only appears if the serial port is used and
the ENQ/STX, ETX/ACK or ACK/NAK protocol is activated.
Press Special (2) key.
Error handling (ErrMode)
On replaces the incorrect character with ?, Off deletes the entire
block.
Press ErrMode (2) key.
Use the
<
(2) or
>
(3) key to select the desired setting.
Setting Options: On/Off
Default Setting: Off
Confirm the setting by pressing the Set key (1).
Block end character (Blockend)
End-of-block character definition; On: LF, FF, CR, VT, ETX, DEL;
Off: ETX, DEL.
Press Blockend (3) key.
Use the
<
(2) or
>
(3) key to select the desired setting.
Setting Options: On/Off
Default Setting: Off
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Special Protocol
Online
Setup
2
1
3
4
Back
Next
ErrMode Blockend
Online
Setup
2
1
3
4
Back
Next
ErrMode=Off
*
Online
Setup
Set
<
>
Exit
2
1
3
4
ErrMode Blockend
Online
Setup
2
1
3
4
Back
Next
Blockend=Off
*
Online
Setup
Set
<
>
Exit
2
1
3
4