Selecting the lc display language – Dascom T2150 User Guide User Manual
Page 54
The Menu
User guide
44
Selecting the LC display
language
This section describes how to make settings in the menu, using the
selection of the national language as an example.
In this user guide all LC display messages are shown in english lan-
guage. Your printer offers also the possibility to show the display
messages in German, French, Italian, Spanish or Turkish language.
This example shows how to change from the English language to
the German language. The same procedure applies to the other lan-
guages (French, Italian, Spanish and Turkish).
Select the Setup mode by pressing the Setup key.
Press the Menu key (1).
Setup mode and Menu mode may be disabled. Hold
down the Setup key while switching on the printer to
enable menu mode. If you want to enable access to this
mode permanently, you need to change the appropriate
setting in the menu; see
.
Press the Next key (4) several times until the display indicates Lan-
guage.
Press the Language key (3).
The display now changes to Parameter mode and indicates English
in the top line.
The lower line displays Set and Exit. The two arrows
<
(2) and
>
(3)
represent the symbols for parameter selection (“
<
” indicates de-
scending and “
>
” ascending). Press the
<
(2) or
>
(3) key until the
desired language is displayed, in our example German.
Online Tractor1
Tear
Online
Setup
2
1
3
4
Adjust Paperway
Menu Char
Online
Setup
2
1
3
4
Print Menu
Online
Setup
Back Next
2
1
3
4
MenLock Language
Online
Setup
Back Next
2
1
3
4
English *
Online
Setup
Set < > Exit
2
1
3
4