Dascom T2150 User Guide - Manual (Page 50)

Settings User guide
40
Setting the first printing
line (TOF)
You can use the TOF function for setting the position of the first prin-
ting line for each paper source and each menu individually.
Before using the TOF function (if fanfold paper is used), you
should first set the tear position; see
Setting the tear position
(page 39) .
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the TOF (3) key.
The paper is fed to the position where the bot-
tom edge of the first printing line is aligned with
the tear edge of the printer. The factory setting
for the first printing position (TOF) is 12/ 72"
(4,23 mm).
This is equivalent to the second line
from the top.
Press the < (2) or > (3) key to move the first printing line to the desi-
red position. You can set values from 0 to 220/72" for fanfold paper
or for single sheets.
Confirm the input by pressing the Set (1) key. Press the Setup key.
The printer returns to the initial status.
The selection made will be retained after switching off the
printer.
Adjust Paperway
Menu Char
Online
Setup
2 1 3 4
TOF
Head Tear Online
Setup
2 1 3 4
First printing line, default First
Readjusted first printing line Readjusted
12/72" 12/72"
0–220/72" 0–220/72"
FormAdj= 12/72"*
Set < > Exit
Online
Setup
2 1 3 4