Dakota Ultrasonics MVX - Manual (Page 6)

2
CHAPTER TWO
QUICK STARTUP GUIDE
Turn the MVX on and off using the switch located on the bottom right corner of the
keypad. When MVX is initially turned on, a flash logo and blinking lights will be
displayed prior to entering into the main measurement screen. Note: This section is
primarily written as a basic startup guide only.
2.1 Selecting The Transducer Type
The first step in using the MVX is to select the transducer type according to
frequency and diameter. By selecting the transducer type from a predefined list, the
MVX can recall specific properties about the transducer. Note: Once the transducer
has been selected, the MVX will store and recall this transducer type every time the
MVX is powered on/off. The type will only change if the user physically selects
another transducer type from the list, or selects a previously saved setup. Therefore,
if you have previously gone through this section and selected the transducer you are
using, proceed to the next section. Use the following steps to select your transducer
type:
Selecting the T ransducer Type
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right and the ESC key multiple times to tab left until
the PROBE menu is highlighted and displaying the submenu items.