CiDRA SONARtrac HD VF-100 - Manual (Page 67)

Copyright © 2006 CiDRA Corporation Page 9-15
20638-02 Rev 01
The following figure shows an example of the second type of
parameter editing. In this case the whole parameter is highlighted and
the up and down arrow keys will cycle between the available settings.
When editing a parameter the ‘ENTER’ key will accept and save the
current value. Alternatively the ‘BACK’ key will revert the current
parameter to the value before editing was begun. The ‘EXIT’ key will
also revert to the previous value (similar to the ‘BACK’ key) and will
exit Menu mode. While in Menu mode the screen will return to
operational mode and resume operation after 5 minutes of inactivity.
OUTOUT CONFIG
• 4-20mA Ch1
POWER SEL.
INTERNAL
Figure 59 Editing Whole Parameter
Table 14 on the following pages gives details on the full menu tree.