chiliGREEN 12 TN120R - Manual (Page 239)

Windows XP Information
AHCI Configuration D - 57
D
5. A SATA AHCI driver diskette will now be created for you.
6. Remove the SATA AHCI driver diskette.
7. Start-up your notebook computer and press <F2> to enter the BIOS.
8. Use the arrow keys to select the Advanced menu heading.
9. Use the arrow keys to select (highlight in white) the Sata Control Sub-Menu, and press <Enter>.
10. Press <Enter> to access the dialog box and use the arrow keys to select Enhanced, and then press <Enter>
again.
11. Use the arrow keys to select AHCI Configuration and press <Enter>.
12. Use the arrow keys to select Enabled and press <Enter>.
Figure D - 31 - BIOS - Advanced - SATA Control Sub-Menu
13. Press <Esc> to exit the menu, and then use the arrow keys to select the Boot menu.
14. Use the “+” key to set the CD-ROM/DVD-ROM Drive as the first device in the boot order from the Boot priority
order menu.
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Enhanced AHCI:
WinXP-SP1+IAA driver
supports AHCI mode.
Advanced
SATA: [Enhanced]
AHCI Configuration: [ Disabled ]
DFOROM(Robson) Support: [Enabled]
Disabled
Enabled
Phoenix TrustedCore(tm) Setup Utility
Sata Control Sub-Menu
Main Advanced Security Boot Exit
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Advanced
Control SATA and PATA
Phoenix TrustedCore(tm) Setup Utility
Sata Control Sub-Menu
Reset Configuration Data: [No]
Legacy USB Support: [Enabled]
Boot-time Diagnostic Screen: [Disabled]
Power On Boot Beep [Disabled]
Battery Low Alarm Beep: [Enabled]
Total Graphics Memory: [128MB]
Graphics Frequency [Power saver mode]