chiliGREEN 12 TN120R - Manual (Page 112)

Upgrading The Computer
6 - 10 Upgrading the System Memory (RAM)
6
8. .Insert a new module holding it at about a 30° angle and fit the connectors firmly
into the memory slot.
9. The module’s pin alignment will allow it to only fit one way. Make sure the module
is seated as far into the slot as it will go. DO NOT FORCE the module; it should fit
without much pressure.
10. Press the module in and down towards the mainboard until the slot levers click into
place to secure the module.
11. Reconnect the fan cable before replacing the bay cover ( in Figure 6 - 6 on
page 6 - 8 ).
12. Replace the bay cover and screws.
13. Restart the computer to allow the BIOS to register the new memory configuration
as it starts up.
Figure 6 - 8
RAM Module
Insertion
5