Caron 6404-4 - Manual (Page 3)

6400/6404 Series Operations Manual Page 3 of 54
Rev F 09/18/14
TABLE OF CONTENTS
Section 1 – Warranty…………………………………………………………………..5
Section 2 – Equipment Overview…………………………………………………. 10
Section 3 – Equipment Installation……………………………………………….. 12
Unpacking
Choosing a Location
Preliminary Cleaning
Leveling the Unit
Filling the Humidity Pan
Connecting a CO2 Supply
Connecting a N2 supply
Connecting Electrical Power
Connecting Alarm Contacts
Section 4 – Optional Accessory Installation / Operation……………………...17
Installing Incubators on a Roller Base or Floor Stand
Connecting the CO2 and/or N2 Gas Guard
Connecting Analog Outputs
Section 5 – Equipment Operation………………………………………………… 20
Changing the Temperature Set-point
Changing the CO2 Set-point
Changing the O2 Set-point
Section 6 – Calibration……………………………………………………………… 24
Calibrating the Temperature display
Calibrating the CO2 display
Calibrating the O2 display
Calibrating the Relative Humidity display
Section 7 – Admin Mode……………………………………………………………. 28
Setting the Over/Low Temperature Alarm
Setting the High/Low CO2 Alarm
Setting New CO2 Tank
Setting the High/Low O2 Alarm
Setting the Low RH Alarm
Setting a System Password
Enabling / Disabling Audible Alarm
Setting the Alarm Ring Back Time
Setting the Door Alarm Delay