Caron 6404-4 - Manual (Page 21)

6400/6404 Series Operations Manual Page 21 of 54
Rev F 09/18/14
An inner door switch is located on the front of
the unit. When the outer door is opened the
blower and gas inject are disabled. Do not
manually override the switch.
SECTION 5 – EQUIPMENT OPERATION
Once the incubator is properly installed with the humidity pan filled and CO
2
source
connected, turn on the power switch on the front upper right side of the incubator. When
power is applied, the incubator will proceed through a series of startup diagnostics.
After this is complete, the incubator will begin to cycle heat and inject CO2. The
displays will begin to move toward their setpoints.
The incubator keypad is designed to produce a simple, easy to understand user
interface that is intuitive and user friendly. With just a few presses of the keys, the logic
behind the user interface is very easy to learn and remember.
There are four basic keys to setup or change any incubator parameter to be setup or
changed.
Enter into a submenu when at Main
Menu or Exit submenu to return to Main
Menu.
Saves any adjusted parameter.
Scroll Up/Down inside a menu or
adjust a selected parameter
Up/Down