AirLive SNMP-FSH2602MG - Manual (Page 37)

AirLive SNMP-FSH2602MG User’s Manual
25
Figure 4-6 IP Configuration
Note3: We do not recommend turning on the DHCP client because the DHCP server
assign the IP randomly. Therefore, users will need to use the Console Port to find
the IP address after assignment. The DHCP client should be used only when
connecting directly to Cable Modem (for remote management) whose service
provider uses DHCP for IP assignment.
Switch Setting
(Administrator menu)
The switch setting menu under the Administrator’s menu is where you can configure
auto-aging time, Broadcast Storm Control, 802.1p Priority, and to enable the 802.1x
protocol. It also provides basic information about the switch and module.
Advanced settings
Figure 4-9 Advance Switch Settings